Microphones : Boundary Microphones : DPA Microphones, Inc. - 5015A

5015A

Series: Surround Sound Microphones

Model: 5015A

More Product Information Below

Compare

Project List

Product Info

Tech Specs

Documents

This is a complete Surround Kit with five carefully factory-matched . Even though the standard tolerances on the 4015s are extremely low, the surround match is even closer. The specially selected 4015 Wide Cardioid Microphones are matched within ±1 dB on both frequency response and sensitivity from mean of set. Recording orchestras or other acoustic ensembles sometimes requires a compromise between blending in the room reverberation and a more precise localization. The natural response and dynamic range make this Surround Kit an obvious choice for precise tone quality and wide dynamic range. This is a great solution for AB, Decca Tree or surround main arrays like our Wide Cardioid Surround Array.

Microphone Type - Condenser
Polar/Pickup Pattern - Cardiod
Warranty - Yes
Spec Sheet available - Yes

Operating Temperature (Maximum): 113 F
Operating Temperature (Minimum): -40 F
Maximum Frequency Response (Bandwidth): 20 kHz
Maximum Frequency Response (Bandwidth): 20000 Hz
Minimum Frequency Response (Bandwidth): 40 Hz
Minimum Frequency Response (Bandwidth): 0.04 kHz
Dynamic Range: 121 dB
Maximum SPL (Sound Pressure Level): 159 dB
Sensitivity: -40 dB
Signal to Noise Ratio: 76 dB
Product Weight: 0.35 lbs
Warranty (Length/Type): 5 Years
Principle of operation: Pressure gradient
Frequency Range: 20 - 20 Hz - kHz
Equivalent noise level, A-weighted: Typ. 18 dB(A) re. 20 µPa (max. 20 dB(A))
Equivalent noise level, ITU-R BS.468-4: Typ. 25 dB (correct with the attenuator in 0 dB or -20 dB setting)
Total Harmonic Distortion (THD): < 1 % up to 139 dB SPL peak
Max. SPL, peak before clipping: 159 dB
Switchable attenuator: 0dB/-20dB
Output Impedance: <200 ohm
Minimum Load Impedance: 2 kohm
Output balance principle: Impedance balancing with Active Drive
Common Mode Rejection Ratio (CMRR): >60 dB
Power supply (for full specifications): 48 V Phantom power (± 4 V)
Current Consumption: 2.80 mA
Connector: XLR-3M. Pin 1: shield, Pin 2: signal + phase, Pin 3: - phase
Output voltage, RMS: >5 V
Polarity: +V at pin 2 for positive sound pressure
Relative Humidity (RH): Up to 90 %
Matching tolerance: ±1 dB
Phase deviation for kit: <10 °
Shipping Height (with packaging): 10 in
Shipping Width (with packaging): 12 in
Shipping Weight: 10 lbs
Shipping Depth (with packaging): 12 in
Color: Black

Surround Kit 1648 kb - Data Sheet

Project List

Suggested Products

Polar Choice Boundary Satellite

by Electro-Voice

Wireless Table Boundary Microphone with Half-caridioid Pickup Pattern

by Sennheiser